Undead Sleds / Rat Rods Rule - Hot Rods, Rat Rods, Sleepers, Beaters & Bikes... since 2007!

Go Back   Undead Sleds / Rat Rods Rule - Hot Rods, Rat Rods, Sleepers, Beaters & Bikes... since 2007! > Need help identifying an item! What the heck is it?!?

Need help identifying an item! What the heck is it?!? Need help identifying a part, car or what ever... post it here!!!

Reply
 
Thread Tools Display Modes
  #1  
Old 02-26-2019, 12:58 PM
Flatbedcowboy Flatbedcowboy is offline
Junior Member
 
Join Date: Feb 2019
Posts: 5
Default International KB11 Trans question

Hello,

I have a 1948 International KB11 with factory air brakes (kinda rare), and all the original equipment has not been changed.

So I need help identifying what the heck all these sticks are for! There are three , plus a lever on the column.

The one on the column Ive been told is for turning off the trailer air brakes for sharp turns. Make sense since it goes into the air valve by the brake pedal.

The next stick on the floor (headed to the right), only goes forward, center, and back. The knob says "Do Not Leave in Neutral".

The middle stick, is for the 5 speed transmission and has a reverse lockout.

The far right stick has a hand lever and goes forward, center, and back only with the lever pulled in.

As far as I know the far left stick and the far right stick both run back to a "second transmission" that is bolted behind the 5speed.

This truck doesnt have a 2speed rear.


[/url]IMG_0330
Reply With Quote
  #2  
Old 02-26-2019, 07:56 PM
kenny c kenny c is offline
Rusty Rat Rodder
 
Join Date: Jan 2012
Location: West Greenwich R.I.
Posts: 2,731
Default

I'm not familiar with that truck. One of the levers that only moves forward and back is most likely for a second trans, high and low range. The other may be for an extra low gear and can only be used when in low range or it is for a forward reverse box so that you have multiple speeds in reverse.
__________________
Tetanus Tornado 49 F6
Reply With Quote
  #3  
Old 02-26-2019, 08:03 PM
kenny c kenny c is offline
Rusty Rat Rodder
 
Join Date: Jan 2012
Location: West Greenwich R.I.
Posts: 2,731
Default

sorry I wasn't paying close enough attention. The lever all the way to the right is usually a parking brake. generally on the drive shaft. The lever on the column is used to operate the trailer brakes manually without using the tractor brakes. At least that is the way it is on newer trucks.
__________________
Tetanus Tornado 49 F6
Reply With Quote
  #4  
Old 02-26-2019, 08:49 PM
Dr Crankenstein's Avatar
Dr Crankenstein Dr Crankenstein is online now
Rocket Surgeon
 
Join Date: Mar 2011
Location: SK CAN
Posts: 5,757
Default

5+4? 5+3?

Old truckers speak up! Bama? MercuryMac?

.
__________________
- The distinction between psychological illness and creative thinking is wafer thin -

1937 Chevy Coupe
1938 Chevy Sedan
Reply With Quote
  #5  
Old 02-26-2019, 11:10 PM
Old Iron's Avatar
Old Iron Old Iron is offline
Rusty Rat Rodder
 
Join Date: May 2011
Location: Willard Mo.
Posts: 11,320
Default

I drove a 59 Binder, when I was 18, that had the two sticks. One was a 5 speed main tranny and the other was a 3 speed Brown-lipe that had Over, Under and Direct.
Yours may just be Low and Direct 2 speed.
Reply With Quote
  #6  
Old 02-26-2019, 11:53 PM
MercuryMac's Avatar
MercuryMac MercuryMac is offline
Builder Junky!
 
Join Date: Jan 2013
Location: Northern Alberta, Canada.
Posts: 2,757
Default

MercuryMac speaking up. My first truck was a '69 Ford, so somewhat newer but fairly similar too. Kenny is probably right on the lever beside the steering column. It is the air valve for applying the brakes only on the trailer, [if you use the foot brakes you get both the tractor and the trailer brakes working together.] The next handle to the right is quite likely the auxiliary transmission shifter, [maybe with the right knob or the wrong knob]. Look under the floor at the base of this gearshift and see if there are two rods side by side going back to that second transmission, or is there only one? If there are two you will have an 'h' or an 'H' shift pattern, [a three speed or a four speed auxiliary]. You might have an inline three speed, though, [forward centre, and back]. The next stick is as you described it, a 5 speed main. My guess on that right hand stick is it is a drum emergency brake on the back of the second trans.
Good luck with that truck.
Reply With Quote
  #7  
Old 02-27-2019, 03:03 PM
Flatbedcowboy Flatbedcowboy is offline
Junior Member
 
Join Date: Feb 2019
Posts: 5
Default

Quote:
Originally Posted by MercuryMac View Post
Look under the floor at the base of this gearshift and see if there are two rods side by side going back to that second transmission, or is there only one? If there are two you will have an 'h' or an 'H' shift pattern, [a three speed or a four speed auxiliary].
It does have 2 on the aux transmission! I cant seem to get the lever to move over in an H type pattern but maybe its bound up somewhere...
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 02:13 PM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Rat Rods Rule Inc.